Help / Troubleshooting

A photo scan did not read right

A few small habits get you a clean read, and you can always check and fix what GetToIt found before anything is added.

Steps

  1. Use good light. Daylight or a bright room works best. Avoid shadows across the page.
  2. Hold steady and fill the frame. Get close enough that the writing is easy to see, and keep the whole list in the photo.
  3. Keep the page flat and straight. Printing or neat handwriting reads best.
  4. After the photo, GetToIt opens Add items and shows what it found, such as "6 lines found". Nothing is added yet.
  5. Tap a line to check it or leave it out. Tap Check all or Clear all to change them all at once.
  6. Missed a line or a page? Tap Take another photo. The new lines are added to the ones already shown.
  7. Tap the button at the bottom, such as Add 5 items.

Lists and labels read differently

  • A written list. Every line starts checked. Uncheck anything you do not want.
  • A product label. If the photo looks like a label, GetToIt says "This looks like a product label, not a list." It checks its best guess at the product name and leaves the rest unchecked. Tap the lines you want.
  • An appliance label. Open the space the appliance is in, tap + Add next to Appliances, then tap Scan make and model on Add appliance. GetToIt fills in Brand, Model and Serial number when it can find them. It is a best guess, so look the three boxes over and fix anything that is off. The photo is not kept, only the text.

Good to know

  • You can always type instead. On a list, type or paste items into the "Add an item" box.
  • On Add appliance, you can type the brand, model and serial number by hand. They are all optional.
  • Lines already on your list say On the list and start unchecked, so you do not add the same thing twice.
  • If a line is spelled a little wrong, add it anyway and fix it later by tapping its words on the list.

If something looks wrong

  • "No text found" or "Couldn't read that." Try again with more light or a closer shot, or type it instead.
  • "No camera." Scanning needs a real iPhone camera. Type or paste the list instead.
  • "Could not read that." Something went wrong reading the photo. Take the photo again.
  • The brand, model or serial number is wrong or empty. Labels are laid out in many ways. Type the right value into the box.
  • The camera does not open. Open iPhone Settings, tap GetToIt, and make sure Camera is on.
  • Still stuck. Email [email protected] with a note about which screen you were on. Someone from support replies within 24 to 48 hours.

More in Troubleshooting

Still stuck? Email [email protected]. Someone from support replies within 24 to 48 hours.